The California Title 24 Building Energy Efficiency Standards are designed to ensure new and existing buildings achieve energy efficiency and preserve outdoor and indoor environmental quality. We have included below useful information regarding underfloor heating and Title 24. To ensure compliance, please consult with a building professional.
Preparing for your project
So either the installer puts a DIN rail on the wall or cabinet, or they can utilize the four mounting holes in the corners of the housing and screw it to a surface.
Warmup strongly recommends that the relay is installed in a separate single gang box to avoid overheating and interference of other cables. Check with your electrician and refer to your local code for specific installation requirements.
Thermostats with an internal GFCI including the Warmup 4iE and WUDG will fulfill this requirement. If a non-GFCI thermostat like our Tempo thermostat is being used, a GFCI breaker will be required. Consult with your local electrician to make sure your installation is properly protected and meets National and Local Electrical Code.
If using a DCM-PRO membrane, scrape/scratch and prime the vinyl to ensure bonding with a highly modified thinset and install the membrane directly to it.
Yes you can heat under glass tiles. The thin-set holds the heat. The glass (silicon) isn’t a very good conductor but the thin-set does the work.
In this guide, we will cover various aspects of the installation process, focusing on key recommendations and requirements that will help you make informed decisions and execute the installation with confidence. We will address topics such as conduit usage, local electrical code compliance, routing of cables, and essential considerations to ensure a safe and effective installation.
Outlined description of when to test your DCM-PRO cable and why you should do it.
This page states that Warmup Mirror Defoggers are not recommended for use in showers.
The conductor cores and ground braid of the 10′ cold lead are factory joined in a water resistant joint assembly to each supply conductor and ground conductor of the unheated lead.
![Thumbnail [200x250]](/wp-content/uploads/Indoor-Systems-Page-Image.png)
![Thumbnail [200x250]](/wp-content/uploads/image-13.png)
![Thumbnail [200x250]](/wp-content/uploads/Projects-Image.png)